for New Equipment Installation - Residential homeowners within service area
Ask About
Energy-Saving Variable Speed Pool Pumps
Pool Owner’s Guide
Before You Call: Five Quick Pool Checks
by Spectrum Pool Care
When something on the equipment pad seems off, a few simple checks can often point to the answer, and they make our conversation faster when you call. None of them need tools.
Look for a tripped breaker or GFCI outlet at the equipment or the main panel. A single reset is fine; if it trips again, leave it off and call us.
2. Timer or schedule
Check that the timer or automation schedule is set to the right time of day. Power outages and daylight saving changes can shift it.
3. Water level
The water should sit about halfway up the skimmer opening. Too low, and the pump can draw air and lose its prime.
4. Baskets
Full skimmer and pump baskets slow the water down. With the power off, empty them and make sure the lids seal snugly.
5. Filter pressure
Compare the pressure gauge with its clean reading. About 8 to 10 psi higher usually means the filter is ready for cleaning.
Always first: safety
Turn the power off before opening a basket or lid, never open a filter under pressure, and if you smell gas near the heater, leave it and call the gas company.
When to Call
Let Us Take It From Here
If a breaker keeps tripping, the pump hums but won’t start, water is leaking at the equipment, or the heater shows an error, those are good moments to call. Tell us what you checked and what you saw, and we’ll take it from there.
Good to know: diagnostic visits may carry a service fee, explained when the appointment is booked. Recommended repairs are quoted separately and begin only after your approval.
